21
4
3
5
21
Operating Instructions
The light emitting diodes on the DataSync hose will
signal, by ashing, that it is time to change the bag
or empty the canister, and even when maintenance
is required. They do not indicate a problem with the
vacuum system, and will not hinder or stop the use
of the vacuum power unit.
c
Flashing LED over Bag icon
GX series only – check the bag, and change if necessary
Flashing LED over Filter icon
DL series only – empty dust recipient and clean lters
d
Flashing LED over Carbon Dust Filter icon
DL & GX series - replace lter
e
Flashing LED over Wrench icon
DL & GX series - maintenance of the power unit is required.
f
Four green LEDs indicate the power level chosen. When
all four ash, they indicate an automatic shut-off (after one
hour of uninterrupted use). Simply restart the power unit by
pressing the hose handle switch.
g
Press the switch to start the power unit at full power. To reduce power level,
press briey on the switch. Power level will reduce by one level. From power
level 1 (lowest), the power unit will proceed to power level 4 (highest). To
stop the power unit, press the switch for 1 second.
%&.0.0%&
Demo mode: If you initiate a demonstration of the DataSync Information Center on
the power unit, (by pressing the reset button on the vacuum unit for 5 seconds) the
hose will also enter a demo mode of LEDs. To stop the demonstration, simply press
the reset button on the hose handle
g
for one second.
DataSync Hose
(DL & GX Series)
Commentaires sur ces manuels